Hawks HPS vs OEM ceramic brake pads - - Infiniti G35 & G37 Forum Discussion | panoramic-3d.ru
Show Your Support Become A Premier Member

    > > >
  • Reload this Page >
    • Hawks HPS vs OEM ceramic brake pads


Hawks HPS vs OEM ceramic brake pads

Thread Tools Rate Thread
Old 07-02-2009, 02:13 PM
Registered User
Thread Starter
iTrader: (7)
Join Date: Dec 2005
location: TX
Posts: 292
Thanks: 0
Thanked 1 Time in 1 Post
Hawks HPS vs OEM ceramic brake pads

After searching on this topic, I was wondering if anyone had any inputs on which brake pads F and R I should go with. I have a 05 g35 coupe with 50K and while the oem ceramic pads have lasted me this long, I was wondering if I should change to hawks HPS. I heard that Hawks HPS last just as long as oem and are good on rotors with little brake dust but with more stopping power. Has anyone had good outcomes with any other brand brake pads? Thanks for any inputs.


EDIT: looks like i will just go with oem brake pads. Comment below stated that F/R full set of oem pads for 05 coupes for ~70 at vendor marketplace section but I did not see anyone who was selling for that price. If anyone can point me to where I can get full set for that price I would appreciate it.

Last edited by 05skyline; 07-16-2009 at 11:53 PM.
Old 07-02-2009, 02:17 PM
Jeff92se's Avatar
Red Card Crew
iTrader: (24)
Join Date: May 2005
location: ɐʍ 'ǝlʇʇɐǝs
Posts: 35,467
Thanked 523 Times in 438 Posts
If you have data that shows the hawk hps gives a shorter 60-0 time hot or cold, list it and I'll fully support your Hawk hps purchase. If not, go oem
Old 07-05-2009, 02:14 PM
Registered User
Join Date: Dec 2003
location: Marietta, Georgia
Posts: 2,514
Thanks: 0
Thanked 3 Times in 3 Posts
It is extremely unlikely that any aftermarket pad can beat oem pads in single or multiple panic 60 mph or 100 mph distances, especially in damp or wet conditions.
Aftermarkets swing the see saw to the hot range and give up cold/warm stopping to achieve any improvement.
There is no free lunch and OEM has spent hundreds of thousands in comparing compounds.
Every company will sell their special compounds to oem for same price due to massive volumes.
After all the chemicals and metals used in a pad don't cost $2.00 per pad.

If you read this you will know more about brake pads than anyone at any dealer in US:




Old 07-05-2009, 11:00 PM
Registered User
iTrader: (2)
Join Date: Apr 2008
location: Brooklyn, NY
Posts: 130
Thanks: 0
Thanked 1 Time in 1 Post
I personally prefer the feel of HPS...they have a more initial bite than the stock pads, and once I got used to them I couldn't go back to oem. I doubt they actually do a better job of stopping the car on the street, but they feel better to me.

HPS are louder and much dustier than my oems were. I also heard that you can pick up a full set of oem pads for something in the $70 range, while HPS go for $110+. Checkout the vendors in the marketplace section.

I say stick with OEM unless you plan on trying the track or autocross.
Old 07-06-2009, 09:18 AM
Registered User
iTrader: (9)
Join Date: Feb 2008
location: Belcamp, MD
Posts: 1,922
Thanked 8 Times in 8 Posts
Quote:
Originally Posted by Rostasteve View Post
I personally prefer the feel of HPS...they have a more initial bite than the stock pads, and once I got used to them I couldn't go back to oem. I doubt they actually do a better job of stopping the car on the street, but they feel better to me.

HPS are louder and much dustier than my oems were. I also heard that you can pick up a full set of oem pads for something in the $70 range, while HPS go for $110+. Checkout the vendors in the marketplace section.

I say stick with OEM unless you plan on trying the track or autocross.
On the brembo coupe I would actually dissagree with you on that. It would seem I have had the opposite response from my HPS pads. I've noticed throughout numerous occassions that the Hawk HPS do not respond well to cold braking or even emergency braking compared to my OEM pads. They do however have significantly less brake dust so I just keep a safe distance fromt the cars in front of me and drive defensively. Im on OEM rotors too, so I hope by switching to a slotted surface I'll get back some of that initial bite I lost.

Sounds like a bad review...depends on what your are looking for, I wanted less dust and less noise, I got that. I also wanted improved higher temp braking performance and I noticed that difference as well when switched pads, just not great when cold or luke-warm.
Old 07-06-2009, 01:51 PM
redlude97's Avatar
Registered User
iTrader: (25)
Join Date: Feb 2006
location: Seattle, WA
Posts: 1,911
Thanks: 0
Thanked 8 Times in 5 Posts
What everyone has to realize is that there were 3 different OEM brake setups for the G35 with very different OEM pad performance designs
If you have an 03-04 AT coupe, 03-04 RWD Sedan or 03-05 G35X, then you have the single piston setup all around with the smaller rotors. Infiniti used very aggressive high dust fast wearing pad design with soft rotors to achieve its class leading braking performance. When the OEM setup is changed out for the HPS or any other lower wearing low dust setup, then performance will drop off significantly.

The 03-04 Brembo pad design is similar to the nonbrembo single piston setup. Aggressive pads with high wear and dust combined for even better performance than the nonbrembo setup. Swapping out the HPS on this setup also yields a significant dropoff in performance.

In 05, due to the high number of customer complaints about the brakes, Infiniti switched up the brakes for a dual piston caliper setup in the front with upgraded larger rotors F/R combined with a less aggressive lower dusting pad. This resulted in similar levels of performance compared to the 03-04 nonbrembo setups without the higher dust and wear associated with them. Using the Hawks HPS pads on this setup *may* yield better feel than stock because of the much less aggressive OEM pads.

This is most likely the reason for the very different opinions across the board on these pads. You have to make sure when you are researching and reading reviews on brake pads that you are comparing results from brake setups matching your own, otherwise you will arrive at a incorrect conclusion
Old 07-06-2009, 02:21 PM
ConradoR's Avatar
Registered User
iTrader: (16)
Join Date: May 2008
location: South Miami
Posts: 2,232
Thanked 160 Times in 114 Posts
Damn this sucks, I changed my brembo OEMs for HPS's a week ago....

Havent used my car enough to notice a major difference, but by the look of this thread... I made a mistake
Old 07-06-2009, 02:40 PM
Registered User
iTrader: (9)
Join Date: Aug 2003
location: Kansas City
Posts: 6,573
Thanks: 0
Thanked 64 Times in 43 Posts
Quote:
Originally Posted by redlude97 View Post
What everyone has to realize is that there were 3 different OEM brake setups for the G35 with very different OEM pad performance designs
If you have an 03-04 AT coupe, 03-04 RWD Sedan or 03-05 G35X, then you have the single piston setup all around with the smaller rotors. Infiniti used very aggressive high dust fast wearing pad design with soft rotors to achieve its class leading braking performance. When the OEM setup is changed out for the HPS or any other lower wearing low dust setup, then performance will drop off significantly.

The 03-04 Brembo pad design is similar to the nonbrembo single piston setup. Aggressive pads with high wear and dust combined for even better performance than the nonbrembo setup. Swapping out the HPS on this setup also yields a significant dropoff in performance.

In 05, due to the high number of customer complaints about the brakes, Infiniti switched up the brakes for a dual piston caliper setup in the front with upgraded larger rotors F/R combined with a less aggressive lower dusting pad. This resulted in similar levels of performance compared to the 03-04 nonbrembo setups without the higher dust and wear associated with them. Using the Hawks HPS pads on this setup *may* yield better feel than stock because of the much less aggressive OEM pads.

This is most likely the reason for the very different opinions across the board on these pads. You have to make sure when you are researching and reading reviews on brake pads that you are comparing results from brake setups matching your own, otherwise you will arrive at a incorrect conclusion
Perfectly said.
Old 07-07-2009, 06:06 PM
's Avatar
PLATINUM SPONSOR
iTrader: (4)
Join Date: Apr 2009
Posts: 1,062
Thanks: 0
Thanked 30 Times in 28 Posts
I had on my 6MT and liked them better than the oem. Dusted less, had better higher heat bite, and didn't make as much noise. I commuted and did some track time on them so I'm not a good gauge of pad life.
Old 07-07-2009, 06:26 PM
Registered User
iTrader: (8)
Join Date: Sep 2007
location: Waco, TX / Leawood, KS
Posts: 1,914
Thanked 7 Times in 6 Posts
ive had both and id have to say the OEM bite harder intially but the HPS bite more linearly to a harder final stop. OEM bites hard initially then kinda dies.

I also have DBA rotors that i installed at the same time as the HPS pads so i cant really be a good reference for OEM rotors.

Also, the HPS dust about the same, maybe 15% more. If you wax your wheels, it will keep 90% of that dust at bay anyways.

best of luck!
Old 07-08-2009, 12:47 AM
Registered User
Thread Starter
iTrader: (7)
Join Date: Dec 2005
location: TX
Posts: 292
Thanks: 0
Thanked 1 Time in 1 Post
Thanks for the inputs...
Old 07-08-2009, 12:49 AM
Registered User
Thread Starter
iTrader: (7)
Join Date: Dec 2005
location: TX
Posts: 292
Thanks: 0
Thanked 1 Time in 1 Post
Quote:
Originally Posted by Rostasteve View Post
I personally prefer the feel of HPS...they have a more initial bite than the stock pads, and once I got used to them I couldn't go back to oem. I doubt they actually do a better job of stopping the car on the street, but they feel better to me.

HPS are louder and much dustier than my oems were. I also heard that you can pick up a full set of oem pads for something in the $70 range, while HPS go for $110+. Checkout the vendors in the marketplace section.

I say stick with OEM unless you plan on trying the track or autocross.



I checked the vendor marketplace section but did not see anyone who was selling F/R full set of oem pads for 05 coupes for ~70. If anyone can point me to who sells it, I would appreciate it.
The Following User Says Thank You to 05skyline For This Useful Post:
slcsd619 (02-23-2012)

Related Topics
Thread Thread Starter Forum Replies Last Post
jsimonk's g35 sedan progress thread jsimonk General Media Share 14 04-15-2017 09:57 PM
Need advice: brakes are not working right miata007 G35 Sedan V35 2003-06 2 08-17-2015 05:36 PM
FS: 05 G35X sedan $6700 wuppiedog G35 Cars 1 08-07-2015 12:16 PM
Need brakes suggestions - 06x sahizzle110 Brakes & Suspension 2 07-29-2015 12:36 PM
OK So What's Nex?!!! EnCr1pt3d Interior & Exterior 9 07-29-2015 04:35 AM


Tags
2004, brake, brakes, ceramic, coupe, g35, hawk, hps, nonbrembo, oem, pad, pads, performance, review, vs
Thread Tools
Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



All times are GMT -4. The time now is 03:04 PM.


Copyright ©2002 - 2017, panoramic-3d.ru All Rights Reserved. We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
  • Ask a Question
    Get answers from community experts
Question Title:
Description:
Your question will be posted in:

Related pages


350z to 370z conversionsmelling burnt rubberhow much oil does a infiniti g35 takealpine mrp-m550gold brembo caliper coversvrc13 vip modularheavy shift knobtrailer hitches for motorcyclesisf joe z exhausttwin turbo engine buildersg37 turbo kit greddysymptoms of bad camshaft sensor2006 infiniti g35 sedan reviewplasti dip colors for wheelscentric premium rotorsoffset tire calculatorpurpose of strut baratlantis tirebuffing scratches out of a carracing aint a thang350z tein coiloverswhiteline bushes303 aerospace protectant canadaengine rattlesinfiniti g35 coupe hoodweapon r dragon air intakeengine bay spray paint10k hid350z nismo edition350z vs g35infiniti g35 coupe 0-60rpf1 center capduralast alternator reviewhyundai tiburon turbo kitpac steering wheel control interfaceinfiniti g35 featurese-ram electric superchargeripod connection adaptervsr rimsnismo kitnissan intelligent key replacement costi monster cassette adapterrockford p2002 amp2007 infiniti g35 accessoriesg35 wide body kitonstar installationvolk gt2003 nissan altima spark plugsviper 791xv2006 g35 mpgpenzoil 10w30how many cans of plastidip for wheelsescutcheon keyhole covermetra install kitnismo key blankg35 lowluk flywheeluprev softwarelexus gs350 forumhid bulbs h4matte bronze plasti dipfast vw gtisrt4 stockgripforce clutchhow to paint carbon fiberlexus gs300 sport design for saleflamethrower car kitrecommended mileage for transmission flushxxr hundred dollar deepjlineselectronic dump exhaustpioneer avic-z110btcamber bolts autozonesuicide doors for chrysler 300baller carskinetix bandk&n recharge kithow to replace headlight wiring harness